DV90 Magnetic Dryer Vent Connector Kit – 90 Degree Dryer Vent Coupling for 4" Vents, Quick Connect Elbow with 3.28 ft Duct, Clamps & Hardware for Tight Spaces

The few inches behind a dryer are where vent hoses go to get crushed, kinked, and clogged with lint, and where a stuck clamp turns every cleaning into a wrestling match. This kit replaces that setup with a rigid 90-degree elbow that routes the exhaust around the corner, so your dryer can sit closer to the wall without squashing the hose. It suits vents that exit through a side wall, floor, or ceiling, and it’s especially handy in tight laundry rooms, closets, and offset layouts where a standard duct won’t bend cleanly.

The magnetic connection is the real time-saver. Self-aligning magnets pull the two halves together and hold them in place, with built-in seal rings creating a snug fit that helps limit air and lint leaks, and you can detach the hose in seconds to pull the dryer out, clean behind it, or clear lint from the vent. The housing is heat- and corrosion-resistant aluminum alloy with stainless steel clamps, and the kit includes everything for the job: the wall assembly, dryer adapter, 3.28 ft of 4" aluminum foil duct, 2 clamps, foil tape, wall anchors, and screws. It fits 4-inch dryer vents only, so measure your vent before ordering and check your dryer manufacturer’s venting guidelines. For anyone tired of fighting their dryer vent, it’s a simple upgrade that makes regular maintenance easier.